Telephone:0086-515-69989788
Fax:69989787
Email:dtdjjx@126.com
Website:www.dtdjjx.com/en
Website:www.dtdjjx.com
Address: No.16, Xinhong National Pioneer Park, Tangyang Town, Dongtai City, Jiangsu Province
The horizontal band saw machine manufacturer introduces the requirements for long-term storage of woodworking band saw machines:
1. Should be parked in a dry room. If you have to stop outdoors, you should choose a flat ground and board it. Cover with a cloth after parking. 2. Before long-term storage, the machinery must be maintained, damaged parts repaired, and thoroughly cleaned to maintain a good technical condition.
3. The arrangement and arrangement at the stop airport shall ensure that the entrance and exit of any machine are not affected by other machines.
4. The fuel control lever of the band saw machine should be placed in the idle position, and each control lever should be placed in the neutral position.
5. The custody of the engine.
The following are some of the more classical methods of using band saw machines:
1. When sawing right-angle corners with straight internal angle sawing method, a round hole can be drilled at the corner first, and then sawing can be carried out according to the arrow direction in the figure. When the turning angle is large, it can be sawed directly.
2. When the bevel is sawed by the bevel saw method, the worktable of the machine tool can be tilted to the required angle. It is also possible to make a wedge-shaped board with a corresponding slope without adjusting the table top of the machine tool and fix it to the table top. When the workpiece is transported along the wedge-shaped board, the required slope is sawed out.
Address: No.16 Xinhong Machinery Pioneer Park, Tangyang Town, Dongtai City, Jiangsu Province | Email:dtdjjx@126.com |
Hotline: 139-0141-5063 | Tel: 0515-69989788 |