Introduction of Full Automatic Band Saw

Introduction to Main Equipment of Automatic Woodworking Band Saw 1. Place the woodworking band saw machine bracket on the basis of the band saw machine. 2. The saw wheel is the main component of the woodworking band saw machine. The upper and lower saw wheels must be adjusted on the vertical plane. The outer edge of the saw wheel should be perpendicular to the center of the frame saw. The lower saw wheel is adjusted by the abutment bolt on the suspension bearing bracket. Adjustment of the upper saw wheel: loosen the locking bolt behind the upper wheel bearing seat, rotate the adjusting screw, and the upper wheel bearing seat and the machine body move relatively so that the position of the upper wheel pressing wheel is accurate on the horizontal plane. Adjustment.

3. The upper wheel lifting device is used to correctly adjust the center distance of the two wheels to be tightened according to the length of the saw blade. Push the handwheel forward and turn the handwheel. The upper saw wheel can rise or fall in parallel. If the inclination of the upper saw wheel needs to be adjusted, the pin on the hand wheel shaft is separated from the left oblique tooth after the hand wheel is pulled back. At this time, the handwheel rotates, only the right bevel gear rotates, and the screw can be used. The right guide pillar is lifted and lowered respectively to adjust the inclination. This will tighten the saw blade and prevent the longitudinal beam. 4. In order to ensure the tension balance of the saw blade in the sawing process, the woodworking band sawing machine is provided with a lever type tensioning device. The weight of the hammer must be increased or decreased according to the width and thickness of the saw blade used, and the tension of the saw blade is usually not less than the recommended value. 5. The woodworking band saw has a saw clamping device to prevent the saw blade from swinging rapidly at high speed. Saw cards can often be raised and lowered in the size of sawn wood. The saw card lining shall be made of hardwood and saw blades along the grain direction. The gap between the saw clip and the saw blade is usually about 0.15-0.25 mm. 6. Woodworking band saw machine is equipped with board device. Adjust the distance between the plate and the saw blade, you can cut the plate and various specifications required. Band saw machine is a kind of sports car band saw machine: the so-called sports car refers to a kind of feeding car for holding logs and feeding band saw blades. The action that PLC needs to complete is the positioning control of the sports car. The power equipment of the sports car is a motor installed on the chassis, which drives the main shaft of the sports car to reciprocate through gear transmission. The sports car enters the work journey, and the sports car withdraws and returns. The working process is as follows: firstly, the sports car platform runs at certain speed intervals. When the system receives the forwarding command again, the same interval runs at the same speed and the interval can be modified. When the system receives the evacuation command, it returns to the trip until the command is cancelled. The forward and reverse rotation of the electric control controls the forward and backward movement of the sports car platform. The direction of the motor is controlled by PLC control system. These are the related contents introduced by the horizontal band saw machine, hoping to be helpful to everyone.